Punch Press Controls

The 3200 Part Revolution Air Clutch Punch Press Control Panel Model 3200 RL (Relay Logic) control system is completely prewired and ready for installation. System comes complete with a well-marked terminal strip for easy, safe and accurate electrical interface to the various punch press components. The control panel can also be supplied with a main power disconnect switch and magnetic motor starters mounted in the same control panel.

Ground Fault Detector
Oil tight push to test type wired to continuously monitor press grounding whenever control power is on.

System Start
Guarded Push Button (Air and Power Interlock)

System Stop
Unguarded Push Button

Brake Monitor
Top Stop Indicator
Oil tight light to detect top stop overrun, this light is tied into the rotary cam to give an electromechanical brake monitoring system.

Hand/Foot Mode
Two Position Keyed Selector for Hand or Foot Mode Initiation.

System On
Indicator Light

Keyed Mode Selector
Off-Inch-Single-Cont.
Four position keyed lock selector switch for supervised selection of mode of operation of the press. When in the inch mode the operator cannot hold or tie one run button down and use the other button to inch the press with one hand operation. Both buttons must be depressed concurrently. Micro-inching optional.

Transformer
To reduce voltage from 480/240 vac to 120 vac secondary.
Consult factory for 208 or 550 volt.

Automatic Continuous Set Up Push Button
This prior action push button must be operated to set-up the press for continuous operation. Once depressed, the operator has a preset length of time in which to depress both palm buttons concurrently to initiate operation in the continuous mode.

Continuous Arm Timer Fused Secondary Pressure Clamp Terminals
Heavy Duty Relay Logic Circuit
With special contact construction for self-checking circuits.

<%=company%>, PO Box 9306, Pittsburgh, PA15225. Tel: 800-937-4334. Fax: 412-262-1197.